Get MAC Address Tool - CCGetMAC

MAC address ipconfig command

MAC address (Media Access Control address) is a quasi-unique identifier consists of a six byte number that attached to most network adapter card or network interface card (NIC). As such, all network cards, whether it’s of Ethernet NIC, Gigabit Ethernet NIC or wireless 802.11a/b/g/n WiFi or HiperLAN adapter, should have different MAC addresses, which also known as Ethernet Hardware Address (EHA) or adapter address.

Sometimes it is needed to know MAC address of the devices like computers, routers, switch or some others. This article describes how to use MAC address ipconfig command.

  • Click on the Start Menu.
  • Click on 'Run..'
  • Type 'cmd' without quotes and press Enter.
  • At the command prompt, type 'ipconfig /all' without quotes. (space between g and /)
  • Alternatively, if using Windows XP, you can use the command 'getmac'.
  • Your MAC Address is listed under 'Physical Address' as a series of 6 groups of two digits, letters and numbers, separated by dashes, such as in the image below. Make sure you get the physical address of the correct network adapter - usually there are several listed.


Figure - MAC Address ipconfig command


Figure - MAC Address ipconfig command result

Tel: +86-731-85537391

Mon - Fri, 9.00-18.00 (GMT+8.00)

MSN: support@youngzsoft.net

support@youngzsoft.net

Submit Your Questions Online



Hot Links

MAC Address Introduction on Wikipedia

Find MAC Address Quickly by CCGetMAC

How to Get MAC Address Step by Step

Lookup MAC Address Using Command

How to Get IP Address from MAC Address

How to Change Your MAC Address